Friday, November 6, 2009

Frankenrocket




I've welded the torch igniter onto my current chamber. As you can see, its rather disproportionate ... a good example of "minimum gauge" issues. The igniter is built around the smallest reasonable orifice sizes (0.014") for the fuel, and the various design constraints lead to what you see here. It was dubbed the "Frankenrocket" by my brother ... and as such it will be known.

I hope to be able to test it this weekend, but in the meantime, I've been working on the next iteration of this engine. I'd like to get away from the igniter for obvious reasons and get back to direct spark. So with some cleverness, a 8mm thread plug, and a step up in my fab skills, I think I've come up with a very compact design that moves the spark plug back onto the injector face and still yields a much smaller engine. I've made a fair start, but I burned out some MOSFETs on the lathe, so I'm stuck waiting for Mr. Postman...






Tuesday, October 27, 2009

What does 100 bucks look like?

This:


From left to right, a standard platinum plug for my car, CR8HIX, R0045J, CM-6, R847, and ME-8. All of them except the first are NGK. All of the interesting NGK plugs are racing plugs and run about $25 each.

The ME-8 has a 1/4-32 thread and is TINY. It is basically the same size as an R/C glow plug. In general, it looks way too fragile and still costs twenty bucks. I'll be trying the R847 next.


Sunday, October 25, 2009

More Igniter Testing


As you can see in the photo, the NGK surface gap plug is holding up well. This is the first plug of its type I've used and you can see that it looks basically untouched after 30 firings or so.

I did some more testing of the igniter. As it turns out, it appears to have been running extremely rich before. I leaned it out some to get smoother operation and there is a big difference in the metal temperature. At the previous mixture ratio, the steel never glowed red.



Saturday, October 17, 2009

Fire again

Over the last couple of months, I've been testing direct spark ignition of my NOP engine. It works, but it can be flakey, and usually makes a rather disconcerting "pop" at ignition. I also tried RC glow plugs, but with standard currents and voltages, they don't provide enough power (i.e. heat to the coil). I think that with PWM you could control or set the power level to get the right wire temperature but that's a rabbit hole I didn't want to go down right now.

So, I finally decided to build a torch igniter. I've been testing various plumbing configurations, spark plugs, and orifice sizes and I think I've arrived at something that works fairly well. It accepts liquids for both oxidizer and fuel, which is nice. I'm not sure if other's torch igniters run on on gaseous oxidizer or not.

The next step is to weld it onto the motor.











Monday, August 10, 2009

Progress?

So, I was out of town for a week on my day job. But right before I left, I was able to try out the Omega amplifier that I bought. The good news is that it works perfectly. The bad news is that the signal it outputs has the same amplitutde as its power source, which in this case is 24V. My TTL counter on the DAQ board didn't mind the 24V one little bit. However, when I went back to use the A/D section of the DAQ, it didn't work. A quick inspection revealed burnt resistors... probably from trying to sync all the current from 24V. So, the board went back to the manufacturer. And I have a non-working test stand.....

I took the downtime as an oportunity to build a Thermocouple amp that I've had partially completed for a while. I now have a four channel amp that outputs 1 mV/degC from Type K thermocouples.

Still no fire...